Refrigeration
unit.........
Right:
The
C450 (or C480) refrigeration unit is the heart of the Ozefridge
system, housing the compressor, condensers, electronics, fan, control system
and external couplings etc.
Two
models:
The
C450 has a Danfoss BD50 compressor and suits most applications while the
C480 uses the larger Danfoss BD80 to suit even larger cabinets, combination
fridge / freezers and commercial applications.
Both C450
and C480 are externally identical with all connections and couplings on the
right side.
All
C450 & C480 units are equipped to operate as air cooled or water & air-cooled
systems.
Installation is made easy with external couplings for refrigeration pipes,
power supply, controller plugs and water supply (if used). (Manual
supplied).
This
equipment is manufactured to the highest standards with first class build quality and
performance an absolute priority.
Model C450
units operate from any DC voltage between 11 & 30 and from any 110 - 250 AC
voltage (Automatic priority to the higher voltage available.
Model C480
units (using the BD80) operate from any DC voltage between 11 & 30. (Model
C480 must use the water cooling option)
Overall
C450 and C480 units are both 290 wide x 290 deep x 195 high. Allow an
additional 50mm minimum at the rear and above
for air movement while extra
space is also needed at the coupling area.
..
All Ozefridge
units are controlled by the exclusive 'Sure-Thaw' management system.
The
'Sure-Thaw' controller with LED display, has programmable settings,
easily adjusted and with automatic memory.
A speed selection switch allows
the choice of 'Normal' where the compressor speed varies automatically while
the 'Plus 40%' position operates the system at maximum. A second switch on
the front panel is for operating as 'Air Cooled' or 'Plus water'.
This allows the water pump to be
switched off during colder months to prevent over condensing.
Another
remote switch is supplied that can plug into the C450 (C480) to allow the
user to over-ride the controller and run the system manually.
The
stainless steel cabinet
has rubber feet and twin hold down screw holes rubber bushed.
The 10mm
water nipples from the condenser match the nipples on the optional P3 water
pump. If required, adding the benefit of water cooling the condenser is
simply a matter of connecting the pump and connecting to the wiring
supplied. All systems are factory pre-equipped ready for the addition of water
cooling if required, without the need for costly upgrading.
Eutectic Tanks............
